Multifan T15-WD Thermostat
QC Part #|
MFR # TT15WDCAM1A
Designed for use on new and existing ventilation systems, the Multifan T15-WD Thermostat is ideal for fans, heaters, curtains on livestock buildings and most electrical devices that need to be automatically controlled. The thermostat switches single phase devices on and off at a set temperature. Water and dust resistant, the thermostat comes completely assembled and ready to install.
May be wired to the Thermostat Piggy Back Cord, QC Part #10921.
- 2° differential
- Sealed casing keeps out water and dust
- Plastic case won't rust or corrode
- 1 full year guarantee
- Used for heating or cooling
- FLA 10 Amp
- 120/240 Volt
- Temperature Range: 32° F to 104° F
- Dimensions: 4" W x 6" H x 2.5" D
- Weight: 1 lb.
Q: Can the cable insert receptacles be replaced with 1/2" PVC conduit adapters? Or is there room to modify the unit and run the run the power wires into the back of the unit?
Show Answer +
A: You should be able to adapt the fitting to 1/2". The electrical box will allow you to wire inside. However, it is not deep enough to wire it from the back of it.
Q: Is this thermostat close on rising or open on rising?
Show Answer +
A: The contacts open and close depending on how you have it wired for either heating or cooling.
Ask a question about this product:
Write Your Own Review
Customers Also Bought
Customers Also Viewed
- Red Devil® Foam & Fill™$6.67